Versions Compared

Old Version 1

changes.mady.by.user Hanno Mueller

Saved on

compared with

New Version 2

changes.mady.by.user Hanno Mueller

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Open MotorScope and check which button is pressed

    1. Pendant E-Stop is detected as pressed when the pendant is disconnected

    2. Chassis E-Stop is detected as pressed when the jumper is missing from J17. The jumper is needed on machines without built-in E-Stop (i.e. Vertex).

    3. ADIO E-Stop is detected as pressed when DIP switch S1 is in the Enable position. Set to Bypass unless an external E-Stop is being used.

    4. If no specific E-Stop button is pressed, but the machine is still in E-Stop without any fault occurring:

      • Press the Front Button to see if it is possible to turn it green.

      • If not, there is a hardware issue:

        • Logic Board

        • Temperature Sensor Boards

...

Filter by label (Content by label)
showLabelsfalse
max5
spacescom.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@141d7
sortmodified
showSpacefalse
reversetrue
typepage
cqllabel in ( "error-code" , "e-stop" ) and type = "page" and space = "SRV"
labelserror-code E-Stop

...