...
...
...
...
...
...
...
...
...
...
...
...
...
This article explains how to align the zoom motor gear to the zoom geat when the zoom stalled. It provides you with the required tools, applicable machines and the link to the service video on youtube which includes detailed instructions on the procedure.
Applicable Machine Models
Vertex 110 - 430
Vertex 251 - 312
Vertex 261 - 342
Excel 4000, 5000, 6000
Excel 501U, 502U, 1000U, 1600U, 660U
Excel 510, 701, 702, 704
Required Tools
3mm Allen Key
4mm Allen Key
Instructions
Info |
---|
The following detailed instructions are presented in the video below and can be displayed by enabling the subtitle/closed captions in the video player. |
Proceed with the zoom gear adjustment if there is too much friction between the zoom and motor gear
Loosen the front screw holding the plastic cable tie that covers the jacking screw.
Loosen the screw mounted vertically that holds the zoom motor.
Tighten the jacking screw, to be able to move the motor away from the zoom.
Position Position the motor gear , where it is slightly touching the zoom gear.
There are 4 screws attaching the motor gear to the zoom cell gear.
The screw at the center is the jacking screw, which pushes the motor gear in and out.
Tighten the screw mounted vertically and adjust the height of the motor gear with respect to the zoom gear.
Adjust the jacking screw to make the motor gear engage with the zoom gear.
*The jacking screw should not be forced into the part. It will damage the surface of the zoom assembly.The goal is to have both the motor and zoom gear rotate smoothly while having a small play between the two gears.
*The gears might slip if the screws are too looseCover the jacking screw with the zip tie holder
Widget Connector | ||||||
---|---|---|---|---|---|---|
|
Related articles
Filter by label (Content by label) | ||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...