| Info |
|---|
This article only applies to P2 Post 2020 Machines |
Problem
The optics calibration starts but fails shortly after. InSpec displays an error message saying that the optics calibration failed.
...
Open the error.trl file. This file is by default located here: C:\ProgramData\Micro-Vu Corporation\InSpec for Windows
If the error reported is: “No strobe signal”, check the USB cable connecting the camera to the zoom board. It needs to be plugged into CAM1 (J8).
Retry to perform an optics calibration.
...
| Page Properties | ||
|---|---|---|
| ||
|