...
| Info |
|---|
This troubleshooting article applies only to post 2020 machines P2 Machines |
If the machine is not operating and the” information light” at the rear status panel of the machine and the firmware LED on the logic board flashes with the following eight-bit pattern as described here:
...
Open MotorScope and check which button is pressed
Pendant E-Stop is detected as pressed when the pendant is disconnected
Chassis E-Stop is detected as pressed when the jumper is missing from J17. The jumper is needed on machines without a built-in E-Stop (i.e. Vertex).
ADIO E-Stop is detected as pressed when DIP switch S1 is in the Enable position. Set to Bypass unless an external E-Stop is being used.
If no specific E-Stop button is pressed, but the machine is still in E-Stop without any fault occurring:
Press the Front Button to see if it is possible to turn it green.
If not, there is a hardware issue:
Logic Board
Temperature Sensor Boards
...