...
| Info |
|---|
This troubleshooting article applies only to P2 Post 2020 Machines |
If the machine is not operating and the” information light” at the rear status panel of the machine and the firmware LED on the logic board flashes with the following eight-bit pattern as described here:
...
The following items provide step by step instructions on how to break down the cause of the issue:
Make sure the pendant is plugged in when the machine is booting up
If the pendant was not unplugged subsequently, there is a hardware issue:
Pendant, Pendant Cable or Pendant Board are defective
Logic Board is defective
| Note |
|---|
plugging in the pendant while the machine is powered up (hot-plugging) is not supported! |
For more details and how to perform debugging, see the following article:
https://microvu.atlassian.net/wiki/x/KQAhug
Related articles
| Filter by label (Content by label) | |||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Page Properties | ||
|---|---|---|
| ||
|