Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

The purpose of the ADIO E-Stop input is to allow Micro-Vu systems that have been released in or after 2020 to respond to safety signals from external sources.

...

  • The machine will come to a stop and become de-energized.

  • The ADIO E-Stop needs to be reset before the machine can be recovered.

  • The standy standby button on the front of the machine needs to be pressed in order to confirm the e-stop.

  • InSpec will prompt the Machine Halted dialog.

...

  1. Open Motorscope by following the folllowing instructions: Motorscope Access

  2. Go to “View” → “Testing” like shown in the picture below

  3. The status can be:

    1. ACTIVATED!
      - when E-Stop is triggered
      - information light is red

      Image RemovedImage Added
    2. RELEASED
      - when E-stop is restored
      - information light is yellow

      Image RemovedImage Added
    3. INACTIVE
      - when machine was recovered or not triggered
      - information light is switched off

...

The following steps need to be performed in order to recover the machine:.
This procedure applies to recovering any E-Stop (Pendant, Maschine, ADIO).

  1. The ADIO E-Stop has to be restored (means .
    (For the ADIO E-Stop the connection between Pin 9 and 10 has to be established)

  2. The standby button on the front of the machine needs to be pressed (the info light will change from red to yellow)

  3. InSpec will prompt an dialog where "recover Recover and continueContinue" has needs to be selected.

    Image Added


    The buttons are grayed out as long as the E-Stop is active.

    Image Added