Page Comparison

Number

Item

Description

1

LED

Z-Axis over current LED:

• Green= OK.
• Red= Unconfigured (see status LED #6). Over current detected on axis.

2

LED

Y-Axis over current LED:

• Green=OK.
• Red= Unconfigured (see status LED #6). Over current detected on axis.

3

LED

X-Axis over Current LED:

• Green=OK
• Red= Unconfigured (see status LED #6). Over current detected on axis

4

Fuse

2A, Z-Brake Fuse.

5

LED Bank

24V_Main

• Illuminated LED indicates the machine is powered.
• Not illuminated indicates the machine is not powered. Could be a defective fuse #7 or defective main connector.

24_MOT

• Illuminated LED indicates the motors are powered.
• Not illuminated LED indicates failure to configure board or a fault/E-stop has occurred.

24V & 5V LOCAL

• Illuminated LED indicates, the board subsystems are powered and working correctly.
• Not illuminated LED indicates a device on the board or possibly a device connected to the board is not powered.

6

LED 

Status LED:

• If Status LED is green then the board is properly configured.
• If Status LED is off after powering up machine, there is likely an issue with the motor amplifier board.
• If Status LED is red 10 seconds after powering up the machine, there is likely an issue with the amplifier board, logic board, or cable between them.

7

Fuse

Fuse size based on machine model:

• 10A FUSE item

• 81152095 used on Vertex 261,341,342.
• 30A FUSE item

• 81152105 used on Excel 51X 70X, 90X, 130X, 170X, 2500.