Problem
This troubleshooting article applies only to post 2020 machines
If the machine is not operating and the” information light” next to the power button and the firmware LED on the logic board flashes with the following eight-bit pattern as described here:
0010 0000 x-axis
0010 0001 y-axis
0010 0010 z-axis
Where 0 indicates a short pulse which is 1/4 second and 1 indicates a long pulse which is 1 second long.
Since this is a high priority error, the internal piezo speaker will also output an accoustic signal with the same pattern.
This pattern indicates a fundamental error of the encoder if it is not plugged in or the cables are otherwise faulty.
Solution
Check the connection of the following cables:
Linear encoder to Breakout Board Cable
Breakout Board to Logic Board Cable