Page Comparison

...

1. Open Motorscope (Motorscope Access) and go to the testing page by clicking on View > Testing.

2. Open the Synchronization Settings and enable the CAM1_OUT1 (Rising) sync signal.

3. Set the LB → ZB Channel Output Trigger Mode to Periodic at 28Hz.

4. Enable CAM1_OUT1 on Channel 1.

5. Click Okay then click Apply Sync Settings. You should see some information counting up, indicating the triggering is active.

• If the trigger values

6. Leave MotorScope open. Open IC Capture and connect to the machine’s camera.

7. Set the correct settings in the Device Properties:

   1. Enable Trigger

   2. Enable IMX Low-Latency Mode

...

9. The camera should be streaming at 28 FPS. Verify the camera is live in IC Capture by e.g. shining a light into the lens.

...

• If the FPS can not be set to 28 then proceed to change the trigger cable and camera. Find the item numbers here: https://microvu.atlassian.net/l/cp/kkuTtwmb