...
...
...
...
A zoom lens failure usually indicates an internal mechanical problem in the zoom cell since the zoom motor rarely fails:
Check if the zoom motor attempts to spin during initialization.
- If it attempts to spin
Check the zoom lens (also known as the zoom cell).
Remove the motor assembly.
Spin the zoom gear and make sure it is smooth.
*If there’s even the slightest mechanical hitch or drag, it will stall the zoom lens and needs to be replaced.
- If it does not spin
There is no current delivered to the zoom motor and the following components should be tested/replaced: Logic Board, Zoom Breakout Board and cable between these two boards.
| Note |
|---|
If no issues were found with the steps above, please refer to the following article to further troubleshoot the cause: Zoom Lens Gear Adjustment |
| Info |
|---|
Micro-Vu typically sells the zoom assembly together to ensure the problem is fixed in one replacement. Please refer to the following articles for warranty, repair, and exchange policies: |
Related articles
| Filter by label (Content by label) | ||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Page Properties | ||
|---|---|---|
| ||
|