Problem
This troubleshooting article applies only to post 2020 machines
If the machine is not operating and the” information light” next to the power button and the firmware LED on the logic board flashes with the following eight-bit pattern as described here:
0010 0100 x-axis
0010 0101 y-axis
0010 0110 z-axis
Where 0 indicates a short pulse which is 1/4 second and 1 indicates a long pulse which is 1 second long.
This pattern indicates that the encoders are counting the opposite direction from the commanded motion.
Solution
Check the following items:
Check all encoder cables are plugged in the right place.
Check the pinning on individual encoder cables.
This can occur if the machine has a faulty configuration. Contact the Micro-Vu support for further assistance