Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Problem

The optics calibration starts but fails shortly after. InSpec displays an error message saying that the optics calibration failed.

The solution is for P2 Machines

Solution

  1. Open the error.trl file. This file is by default located here: C:\ProgramData\Micro-Vu Corporation\InSpec for Windows

  2. If the error reported is: “No strobe signal”, check the cable connecting the camera to the zoom board. It needs to be plugged into CAM1 (J8).

  3. Retry to perform an optics calibration.

  • No labels