Color Camera Replacement

Turn off the machine and remove the Z cover.

Unplug the ring light and remove the sheet metal camera cover.

Note the orientation of the camera.  (The direction it is pointed.) Loosen all three par-centric adjustment screws and remove the camera and camera mount.

Unscrew the camera from the mount and replace with the new camera.  Mount camera in the same orientation of the older camera.

Reinstall in the opposite steps, but do not install the camera cover at this time.

Open InSpec and make sure new camera is working and mechanically set the par-centric.

Turn off the machine and close InSpec.  Reinstall camera cover and the ring light.

Turn on the machine and enter InSpec.

Set magnification to the highest setting, focus on the lights calibration target, select the surface ring light and push the auto-light button.

On the top of the camera, push the center button to bring up the camera menu which will display in the camera view in InSpec.

Using the bottom button move down to the White Balance setting and push the center button.  (Note:  The White balance setting should be set at "Push Lock") 

When the camera is finished adjusting the light move down to the SAVE ALL selection and push the center button.

Select Exit.

Run optics and lights calibrations.